Hook up oxygen tank

Further information
Contents:


  1. Using Oxygen Safely
  2. Open the Valve Slowly and Completely
  3. Using Oxygen Safely - What You Need to Know
  4. Why might I need to use oxygen at home?
  5. How to Use an Oxygen Tank Valve

Keep the oxygen system in a well-ventilated area, away from draperies and walls. Do not place concentrator in a closet. Do not put oxygen tanks in closets or leave them unsecured. To remove the gauge from the empty cylinder, unscrew the chrome "T" shaped handle on the right hand side of the gauge. Lift the gauge off the empty cylinder, set the empty cylinder aside. Remove the white band that marks a full cylinder.

Be sure the dial on the gauge is facing in the same direction as the dial on the cylinder. Place the gauge over the valve on the full cylinder. Important Observe that a plastic washer is in place to prevent leaks.

Using Oxygen Safely

Be sure the 2 round, metal pins on the gauge fit into the 2 guide holes on the cylinder valve. Firmly tighten the chrome "T" shaped handle on the right side of the gauge. This secures the gauge to the cylinder. If the cylinder hisses near where the gauge attaches to the cylinder, tighten the chrome "T" shaped handle more securely. If it is still leaking, a new plastic washer may be helpful. Primary Oxygen System - Large Reservoir Unit The Sparrow Medical Supply Representative will place the large reservoir unit in the location that you specify, a central area is recommended when possible.

The reservoir must not be placed near heat sources. A long length of tubing may be attached to allow you greater mobility to adjacent rooms or areas. If you wish to change the location of your unit, please call Sparrow Medical Supply and a representative will relocate the unit for you. A humidifier bottle may be attached to the threaded outlet on the front of the unit. Make sure all connections are tight in order to prevent leaks.

Open the Valve Slowly and Completely

Small diameter tubing from your oxygen cannula or mask is attached to the plastic nipple. The oxygen flow control knob is located just above the nipple. This knob is used to turn the oxygen "on" or "off". Use your oxygen as prescribed by your physician; in other words, the specified number of hours per day at the ordered flow rate.

Using Oxygen Safely - What You Need to Know

If your doctor changes your oxygen prescription, please notify Sparrow Medical Supply. Adjust the flow control knob to prescribed liters per minute, which is prescribed by your doctor and attach the cannula or mask to your face. When not using your oxygen, always turn the flow control knob to "zero" or "off". A meter located on the top of the reservoir unit indicates the amount of oxygen remaining.

How to set up a portable oxygen bottle

Use the following link for a chart of Duration Times. A Sparrow Medical Supply Representative will deliver additional liquid oxygen to your home one to two times per week, depending upon your usage. Cryo2 Portable Oxygen System - Small Unit The portable oxygen system is designed to provide a limited supply of oxygen while away from home. View the following link for a chart of duration times. Liquid Oxygen Duration Times.

If unit has "pulsed" switch and is set at "pulsed" rather than "continuous", it will provide oxygen for a longer period of time. To fill the portable unit: Wipe moisture off the metal couplings on the large reservoir and on the bottom of the small portable unit. Turn the flow control knob on the portable unit to "zero". The flow control knob on the large reservoir unit may remain on the prescribed setting during filling of the portable.


  1. Using Oxygen at Home.
  2. Quick Links.
  3. sofia vergara dating.
  4. interracial dating websites reviews.
  5. speed dating anchorage.

Mate the metal coupling on the large reservoir with the coupling on the bottom of the small portable unit. Align the yellow arrows so that they point at each other. Lift the black handle marked "vent valve". You will hear a hissing sound as the portable unit fills, this takes approximately 30 seconds. The unit is full when you see a large amount of vapor escaping from the bottom of the portable. To stop filling, flip the "vent valve" handle down. Lift the portable unit to separate it from the large reservoir tank. Lift the portable unit by the handle or strap attached to the scale.

Observe that the scale indicates "full". If the scale does not read "full", repeat steps 4 through 9. To use the portable oxygen unit, simply turn the "Flow Control" knob to the prescribed setting and attach the tubing. No humidifier bottle is necessary due to short term use. Occasionally check the scale to determine the amount of oxygen remaining in order to prevent the possibility of running out of oxygen while away from home.

Following are approximate hours of oxygen remaining with flow control set. Liquid Oxygen duration of use times. Do not attempt to only partially fill unit. This may adversely effect the operation of the portable unit. Always fill the unit to the "full" mark on the scale. Re-check the scale often to prevent possibility of running out. Unit will not store oxygen for extended periods of time during non-use due to evaporation.

This waste of oxygen can be minimized by keeping the unit out of direct sunlight and in a cool environment. When returning home, you should use the rest of the oxygen in the portable unit. When used in the "Pulse" mode, the battery must be charged at least two hours prior to use. Overnight charge is recommended. To give a treatment: Measure the right medication dose as shown on your prescription label or as instructed by your physician. Add diluents as prescribed. Sit upright in a chair or in a slight recline. Place the mouthpiece between your teeth, close your mouth and breathe in slowly through your mouth.

Take breaths deeper than normal. Hold your breath for as long as you comfortably can before you breathe out. Breathe out slowly in a relaxed way passively. You should pause after about 5 minutes and try to cough. This will help to move any plugged up mucous out of your airways. You should turn the nebulizer off when you rest so you don't waste your medication. Keep breathing this way until all your liquid medication is used.


  1. Never Use Lubricant or Oil!
  2. Equipment Instructions - Sparrow Health System.
  3. love 2 hook up uk.
  4. Using Oxygen at Home - What You Need to Know.

This will be done when the nebulizer is no longer making a visible mist. To clean your nebulizer kit: Rinse under hot tap water for 30 seconds to remove detergent residue. Allow to air dry. For reusable nebulizer only, clean daily in dishwasher using top shelf. Once each day - take the nebulizer apart, soak in a three parts hot tap water and one part white vinegar 30 minutes. Refer to your prescription container for proper medication storage or ask your pharmacist.

Refer to the manufacturer's manual or training instructions provided at time of delivery. Wash each part of the nebulizer kit after each treatment in hot, soapy water. Rinse with hot water.

Why might I need to use oxygen at home?

Air dry on a clean cloth. Nebulizer kits may be cleaned in a dishwasher. This material must not be used for commercial purposes, or in any hospital or medical facility. Failure to comply may result in legal action. Medically reviewed on Dec 21, You may need extra oxygen if you are not able to breathe enough oxygen on your own.

How to Use an Oxygen Tank Valve

You need a doctor's order to get oxygen therapy. The order will include how much you need, and how often you need it. Use oxygen as directed. Your healthcare provider will pick your oxygen supply based on how much oxygen you need, and how active you are. This nozzle is where the air travels and you'll have to attach plastic tubing to it. Line the tubing up with the nozzle and firmly press up so that the tubing fits snugly around the regulator nozzle.

Unscrew the top valve one full turn. A tool should have come with your oxygen tank that can fit over the top valve on the gas tank itself. Position the wrench over the valve and turn it counter clockwise to open up the airflow from the tank to the regulator. Watch the needle on the gauge go up. When you unscrew the valve on the top of the tank, you should see the needle move, signifying that there's air coming through your tank.

You should also hear and feel oxygen coming through the tube that you connected to the regulator. Adjust the level of oxygen coming through the tank. Your doctor should have informed you of the number that you should keep your regulator at.

WHAT YOU NEED TO KNOW:

Follow their instructions and adjust the level of oxygen by turning the dial on the side of the regulator up or down. On the dial, you should see numbers. Move the dial until the number lines up with what your doctor told you. Insert the prongs on your cannula into your nostrils. The cannula is the small tubing that fits inside of both your nostrils. Put the parts where the air is coming out into your nose and stick the rest of the tubing up and over your ears. This will keep it in place as you walk around. Sometimes your oxygen tank will come with a full oxygen mask.

If you have a facemask, place the mask over your mouth and nose and put the straps on the mask behind your ears. Replace your nasal cannula every weeks. Using the same cannula for over a month will make you more prone to infections. For the same reason, you should also change your cannula after you've been sick.