Tach dwell meter hook up

Contents:


  1. How a dwell meter works
  2. How to Connect Dwell Tach Meter - CorvetteForum - Chevrolet Corvette Forum Discussion
  3. Checking the dwell angle

When I used to set up my Y-block, I would set the dwell at 26 degrees.

The spec was By setting it at 26, then when the point contact block wore down, the dwell would increase , but still be in spec. As the dwell increased, the timing retarded, I believe for each 2 degrees of increased dwell, the ignition timing would retard 1 degree. At any rate, with the new electronics, this stuff is now a thing of the past. I sort of miss tuning the old Fords. Find all posts by Superbru.

I used to like to point a timiing light at the fan and watch it. Find all posts by jagabom. There was an old rule-of-thumb that the points wear. Here's a neat article that shows just how useful a dwell meter can still be today. Find all posts by BB.


  • Connecting the meter;
  • .
  • dating after the death of a wife.
  • How to Connect Dwell Tach Meter.

Hey Barry Very good article , the things you can learn on here are endless. And who says you can't teach old dogs new tricks.

How a dwell meter works

Find all posts by walkhaulsey. Ponts were simple but the electronic systems are much better. Damn but I changed out a lot of points Some of the older "period" shop manuals explain some of the interesting dwell meter uses.

How To Install A Tachometer.

Last edited by Torque1st; at Setting the dwell on a Dwell, tach meter help please. To gap or to dwell - That is the question. Thread Tools Show Printable Version. Posting Quick Reply - Please Wait. The following errors occurred with your submission. Quote message in reply?


  1. online dating name female!
  2. under 20 dating site;
  3. does radioactive dating with isotopes of uranium and thorium provide.
  4. online dating for twenty somethings!
  5. christian dating sites london;
  6. Anyone know how to use a Tach-Dwell meter? - CorvetteForum - Chevrolet Corvette Forum Discussion.
  7. he is always on dating sites.
  8. We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon. Make sure the small metal cover on the side of the distributor is closed. Jeffrey Caldwell has been a freelance writer for over five months and has published over articles on websites like eHow and Trails. Caldwell writes articles on a wide range of topics including travel, camping and automotive mechanics.

    How to Connect Dwell Tach Meter - CorvetteForum - Chevrolet Corvette Forum Discussion

    Checking the Dwell Angle Turn the engine on. Turn the Allen wrench slowly to adjust the dwell angle to the correct setting. Remove the electrical leads from the ignition coil. Tip Make sure the electrical leads for the tach dwell meter do not interfere with any of the moving parts on the engine such as the engine fan.

    Also make sure the electrical leads do not contact any part on the engine that develops excessive heat, such as the exhaust manifolds.

    Checking the dwell angle

    Some distributor caps do not have a window to insert an Allen wrench to adjust the dwell angle. If yours does not, you will have to stop the engine, remove the distributor cap and incrementally adjust the dwell angle. Warning While working on a running engine, keep your hands away from moving parts on the engine, such as the accessory drive belts or any part of the engine that becomes excessively hot. Items you will need Dwell meter Allen wrench.